Bevel gear reducerIt is a 3-stage helical-umbrella-helical gear reducer motor with high double torque power and long life gear. It is available with foot device, flange device and shaft mounting type. The gear reducer is a combination of a geared motor and a large reducer. There is no need for couplings and adapters, and the structure is compact. The load is distributed on the planetary gear, so the load capacity is higher than that of the general helical gear reducer. It meets the needs of small space and high torque output.

1. Reliable industrial gear transmission elements;

2. Reliable structure combined with various inputs to meet the special requirements of use;

3. It has high power transmission ability and compact structure, and the gear structure is determined according to the module design principle;

4, easy to use and protect, configure and select materials according to technical and engineering conditions;

5, Torque scale from 36,0000Nm to 1,200,000Nm.

The reducer is widely used in the fields of petroleum, chemical, plastic, rubber, food, textile and other mechanical equipment, among which the gear reducer is a relatively widely used model. However, the gear reducer will have various failures after a long time of use. , Excessive oscillation is a common problem. What factors will cause the bevel gear reducer to oscillate too much?

The first factor is that the frame of the reducer oscillates greatly. The oscillation frequency of the frame directly affects the speed of the reducer, so if the frame oscillates too much, the reducer will be unstable during operation.

Factor 2, the transmission machine is out of balance. The transmission machine imbalance of the gear reducer is mainly manifested in the poor calibration line between the motor and the driver, so as long as the calibration line is adjusted to restore the connection between the driver and the motor, the operation of the motor bearing can be stabilized.

Factor 3, the bearing wear is too large, which is a very common factor that causes excessive vibration of the reducer, mainly because the bearing works for a long time or the gap is too large, which causes the bearing friction and heat to damage the bearing. During the sliding bearing, it is easy to cause bearing damage, so in the During maintenance, special attention should be paid to the lubrication of the bearing.