Today, we introduce the installation method of Liming reducer:

1. The Liming reducer should be firmly installed on a horizontal and stable foundation or base, the oil in the oil tank should be able to be discharged, and the air cooling circulation system should be smooth. Basically unreliable, it will cause vibration and noise during operation, and promote rolling bearings and transmission. Damage of gears. When there are protrusions in the connection part of the transmission system or when the transmission gear and sprocket chain transmission system are selected, the safety device should be modified. When the output bearing is subjected to a large axial load, the thickened type should be used.

2. When installing the equipment according to the regulations, it is necessary to ensure that workers can easily access the oil level gauge, ventilation plug, and oil drain plug. After the installation is in place, a comprehensive and orderly inspection of the accuracy of the installation parts should be carried out. After installation, the clamping of each standard part is stable. The performance must be able to rotate flexibly. The Liming reducer is splashed and lubricated by the oil pool. Before operation, the customer needs to remove the plug of the vent and replace the vent plug.

According to different installation parts, open the screw of the oil plug and check the height-width ratio of the oil reference line. After the oil is supplied from the oil plug to the overflow of the oil from the oil plug hole, the full-load test can be carried out after the oil plug is firmly and accurately sealed. Less than 2 hours. The operation should be stable, without shock, vibration, noise and oil leakage. If there is any abnormality, it should be eliminated immediately. After a certain period of time, the oil quantity should be checked again to avoid possible leakage of the casing. If the working temperature is too high or If it is too low, the type of grease can be changed.

3. When installing the Liming reducer, great attention should be paid to the alignment of the center line of the transmission system management center, and the error should not exceed the application compensation of the ordinary coupling. The high-quality alignment can prolong the service life and obtain the ideal transmission system with high efficiency .

4. When installing the transmission equipment on the output shaft, hammering is not allowed. Generally, the transmission equipment and the anchor bolts are pressed into the installation fixture and the shaft end thread, otherwise the internal parts of the reducer will be damaged. Choose a very rigid mobile coupling Therefore, improper installation of similar couplings will cause additional additional loads, resulting in initial damage to the rolling bearing, and even breakage of the output shaft in severe cases.