usedPrecision servo reducerEveryone knows that in daily use, the reducer must be inspected every time before starting the reducer, and only after the inspection confirms that the reducer is normal, can the reducer start to be used. Under the same power of the servo reducer, the component of the carburized and quenched gear will be about 1/3 of the component of the quenched and tempered gear. Therefore, in view of the structural characteristics of the planetary gear reducer and the load characteristics of the gears, hardened gears should be widely used.

There are many heat treatment methods for the planetary gear reducer to obtain hard-tooth surface gears, such as surface quenching, overall quenching, carburizing quenching, nitriding, etc., which should be selected according to the characteristics of the planetary gear reducer. The correct installation, use and maintenance of the worm gear screw elevator are important links to ensure the normal operation of mechanical equipment.

Therefore, when you install a planetary reducer, you must strictly follow the installation and use related matters below, and install and use it carefully. And the inspection work is not only reflected in the reducer before use, we need to check the reducer first in the following situations:

1. When newly purchased: The reducer just received may have quality defects due to the manufacturer’s production and packaging problems, and may also be damaged during transportation. Therefore, we are required to first receive the newly purchased reducer. Check it.

2. The initial use of the reducer: Generally, the reducer can be used after the device is completed, and in order to ensure the normal operation and function of the reducer during use, we also need to conduct inspections before the first use to ensure that the reducer device is functioning properly.

3. Reuse after a long-term shutdown: a precision servo reducer that has been shutdown for a long time may have certain failures due to environmental factors, and it may not be able to operate and use normally. Therefore, when we use the reducer that has been shut down for a long time, we need to check it first.