The servo reducer is the weight of the reducer gear transmission, which is generally proportional to the weight of the gear, and the weight of the gear has a great relationship with its material and heat treatment hardness. For example, under the same power, the weight of the carburized and quenched gear will be the quenched and tempered gear. Therefore, in view of the structural characteristics of the planetary gear reducer and the load characteristics of the gear, hardened gears should be widely used. There are many heat treatment methods for obtaining hardened gears, such as surface quenching, integral quenching, Carburizing, quenching and nitriding should be selected according to the characteristics of the planetary gear reducer.

In the reducer family, planetary reducer is widely used in servo, stepping, DC and other transmission systems due to its small size, high transmission efficiency, large reduction ratio and high precision. Its function is to ensure a very small range of transmission. Under the premise, it is mainly used to reduce the speed, increase the torque, and reduce the ratio of the load\/motor moment of inertia. In order to better help users make good use of the servo reducer, the reasons for the damage of the reducer and the drive motor are analyzed, and how to correct the Install the planetary reducer.

Correct installation, use and maintenance of the reducer is an important part of ensuring the normal operation of mechanical equipment. Therefore, when you install the servo reducer, please be sure to assemble and use the following installation and use-related matters carefully.

First of all, before installation, confirm whether the motor and reducer are in good condition, and strictly check whether the size of the connection between the motor and the reducer matches. This is the size and matching tolerance of the motor positioning boss, the input shaft and the reducer slot, etc.

Then, unscrew the screw on the dust hole on the outside of the flange of the reducer, adjust the clamping ring of the PCS system so that the side hole is aligned with the dust hole, insert the inner 6 corners and tighten. After that, remove the motor shaft key.