Low backlash worm gear reducer is a kind of transmission machinery with compact structure, large transmission ratio and self-locking function under certain conditions. It is one of the most commonly used reducers.
1. Regularly check whether the installation foundation, seals and drive shaft are normal.
2. During normal use, the oil level of the lubricating oil should be checked frequently (observed through the oil window), and the high temperature of the lubricating oil should be lower than 85°C. In case of abnormal noise caused by abnormal temperature rise, it shall be shut down immediately for inspection, and then continue to use after troubleshooting.
3. After running-in and load test, the new replacement parts must be used formally.
4. Do not hit the reducer shell with a gravity hammer to avoid damage.
Second, the use inspection and replacement of the lubricating oil of the low backlash worm gear reducer:
1. The working environment temperature of the reducer is -40~+40℃. When the ambient temperature is below 0°C, the lubricating oil must be heated to above 0°C to start or use low-freezing point lubricating oil.
2. The worm pair or reduction gear pair is used for the first time or replaced with a new one. After 150-400 hours of operation, replace the lubricating oil, and the subsequent oil change interval is less than or equal to 4000 hours.
3. Regularly check the quantity and quality of the oil, keep enough lubricating oil, and replace the oil mixed with impurities or deteriorated in time.
4. The fuel injection volume should meet the requirements. It is forbidden to mix oils of different brands, and oils of the same brand and different viscosities are allowed to be mixed.
5. Regularly check the quantity and quality of the oil, keep enough lubricating oil, and replace the oil mixed with impurities or deteriorated in time.
Gear processing of low backlash worm gear reducer, gear motor, worm gear, continuously variable transmission, gear commutator, worm gear reducer, screw jack, micro cycloid reducer, precision planetary reducer, spiral bevel gear reducer, Hard tooth surface helical gear reducer, reducer parts processing are available in stock.
Apr 11, 2022
Apr 06, 2022